Type A+6mA (DC) residual current protection module DXE-L1

$1≥100Piece/Pieces

Payment Type:	T/T
Incoterm:	FOB,CFR,CIF,EXW,FCA
Min. Order:	100 Piece/Pieces
Transportation:	Ocean,Land,Air,Express,Others
Port:	SHANGHAI,NINGBO,GUANGZHOU

Contact Now

Product Description

Product Attributes

Model No.: DXE-L1

Brand: DEXIE, OEM service is available

Place Of Origin: China

Packaging & Delivery

The file is encrypted. Please fill in the following information to continue accessing it

Product Description

Product Introduction

● Dedicated to charging piles

● Switching output

● Strong anti-interference ability

● Measure DC6mA & AC30mA

● Fluxgate principle

● High resolution

Standard adaptation

● GB/T 41589—2022/IEC 62752:2018. MOD

● GB/T 40820—2021/IEC 62955:2018

● GB/T 18487.1-2023

Electrical data

Parameter	Minimum	Standard	Maximum	Unit
Operating Voltage	4.85	5	5.15	V
Power consumption	30	-	110	mW
Voltage input/output, low level	0	-	0.6	VDC
Voltage input/output, high level	4.2	-	5	VDC
Pressure resistant	2.5KV,50Hz,1min
Creepage distance	-	6	-	mm
Maximum overcurrent	-	20	-	A(rms)
Weight	-	10	-	g
Power on time	-	60	-	ms
Operating temperature	-40	25	85	℃
Storage temperature	-40	25	85	℃
Working humidity	0	-	95	%

Residual current related characteristic parameters - operating current

Residual current related characteristic parameters - action time

Pin definition

Pin number	Pin name	Function Description
1	VCC	● Product power supply pin, standard supply voltage 5 VDC ● Input voltage range requirement is 4.85~5.15 VDC, power output capability > 100mA ● Power supply ripple ≤ 150mV ●It is recommended to add magnetic beads and filter capacitors to the power supply end and place them close to the pins.




2	GND	● Product power ground pin
3	VO	● Product action signal output pin ● When it is detected that there is residual current in the line exceeding the threshold, the output level changes from low to high. ● It is recommended to add magnetic beads and filter capacitors to the power supply end and place them close to the pins.



4	CHK	● Product self-test input pin ● Before turning on charging, conduct a simulation test on the product through this pin to verify whether the product functions normally.


5&6	NC	Empty feet